MANSOQ Facility administration
Reorder locations
This flow describes how to change the order of a location among its sibling locations in MANSOQ. Pre-requisites - The location and its sibling locations are set up under the same parent location. - You have the permissions listed below.…
3.1 · versioned documentation · 2 min read
Overview
This flow describes how to change the order of a location among its sibling locations in MANSOQ.
Pre-requisites
- The location and its sibling locations are set up under the same parent location.
- You have the permissions listed below.
Permissions
| Permission | Access |
|---|---|
| Can Create/Update Facility Locations | Lets you change the order of locations in a facility. |
Steps
1. Open the location list
Open the location list in the table view or the card view. See View locations.
2. Find the location to move
Find the location that you want to move.
3. Move the location
Select the up arrow to move the location earlier among its sibling locations.
Select the down arrow to move the location later among its sibling locations.
MANSOQ swaps the position of the location with the sibling location directly above or below it.
Note: If the move takes the location past the edge of the current page of results, MANSOQ opens the neighboring page to complete the move.
Note: Reordering changes the position of a location among its current sibling locations only. You cannot move the location under a different parent location.
Expected Outcome
- The location shows in its new position among its sibling locations.
Related
Concepts:
Flows:
Source evidence
References are pinned to the private MANSOQ source repository. Repository access is required to open these links.